Don't be SLINGED & TRICKED into a 1yr warranty get the best LIFETIME WARRANTY here!
You want to make sure that the light strips are mounted away from any moving parts and heated areas. If the light strip becomes damaged, it will void the warranty.
The Strips are waterproof, but you want to keep the control box as dry as possible. Exposing the control box to moisture over a long period of time will result in malfunctioning and possibly failure.
Yes, we offer add on kits for almost every one of our motorcycle kits. The box can support up to 50 strips / pods.
The laws and rules regarding automotive LED lighting vary from state to state. Please check with your local municipality about the laws in your area.
We recommend and offer a cleaning prep agent called 3M Adhesion Promoter. It is a single use sponge applicator that will remove dirt and oils that will not allow the double sided tape to adhere. The 3M Adhesion Promoter also allows for a chemical bond with the glue on the double sided tape, creating a secure bond. If you don't have the 3M Adhesion Promoter, we recommend using rubbing alcohol to clean the motorcycle's surface.
You can cut the strips every 3 LEDs on the copper line. There is a mark indicating the correct location to cut. (Cutting Strips will void Warranty)
The control box can be hooked to any 12 volt source and a ground source. You can use the motorcycle's battery or fuse box for power and a clean bare metal area for a good ground source.
LED lights draw very low milliamps. As long as the battery is holding a solid state of charge, there should be no issue.
The strips can melt from overheating if the strip itself falls off the application due to improper installation or if the strip is too close to the muffler or any heat source. I would suggest placing the strip at least 4-6 inches away from a direct heat source and use wire ties when and where available.
Your best bet is to run the wiring through the frame rails or where you have the best location to run and hide the wiring. A lot of times you can run wires along the factory wire harness and use zip ties to mount the wiring in place.
The wires are not intended to be cut because it will void your warranty. If the wires do have to be extended, you can use standard 18-20 gauge automotive wiring, but this is to be done at your own risk. WARRANTY IS VOID
The light strips cannot be used as turn signals. Each strip plugs into one main power harness and the strips will all be powered once the kit is turned on.
You should contact your local municipal to see what the rules and regulations are regarding riding with LED lights on.
Copyright © 2018 Lite Your Sling - All Rights Reserved.
Lite Your Slingz and the products offered for sale by us are not affiliated with or endorsed by Polaris or BRP.
Lite Your Slingz will be held harmless regarding your usage of any and all Lite Your Slingz products. The manufacturer reserves the right to change/modify product without notice. Actual product may vary in transparency depending on plate color, writing, shade and lighting conditions.
NOTE: The manufacturer, retailer, wholesaler assumes no responsibility for any use, misuse or application of this product in violation of any applicable law. Before installing this product, please check your state and local laws and regulations. Use of any Lite Your Slingz product is solely used for show purposes, off road purpose only and not to be used in any way that may violate any laws or jurisdiction. Lite Your Slingz and will not be held responsible from the use or illegal use of such products. Lite Your Slingz or retailers will not be held responsible for malfunctioning items that is not installed by us or by one of our authorized installers.